As an Amazon Associate I earn from qualifying purchases.
Mfjs lighted cross-needle meter shows swr, 8 position antenna switch lets you select 2 coax lines, forward and reflected power all at a glance in 300/60 and 30/6 watt ranges, random wire/balanced line or dummy load direct or through.
MFJ #ad - You’ll know exactly what to do by simply watching the display. Adjust your yagi, loop and other antennas, change antenna spacing and height and watch SWR, quad, resistance and reactance change instantly.
Super easy to use! just set the bandswitch and tune the dial -- just like your transceiver. Complete ham radio test station with frequency counter, SWR/Resistance/Reactance/Coax Analyzer, RF signal generator, Capacitance/Inductance Meter and much more! 1 Year Manufacturer Warranty Included.
8 position super antenna switch lets you select two coax fed antennas, random wire/balanced line or built-in dummy load through your MFJ-949E or direct to your transceiver.
8 to 30 MHz. Lets you easily read swr, true peak forward and average reflected power simultaneously on 300 Watt or 30 Watt ranges. Custom inductor switch the inductor switch is the most likely component to burn up in any antenna tuner. Lamp has on/off switch, requires 12 vDC or 110 VAC with MFJ-1312D Not included.
Built-in frequency counter * SO-239 coax fed antenna connector * Connector for random wire or single wire antennas. Automatically match antennas with impedance of 12 to 800 ohms * Handle 600 watts PEP SSB/600 watts CW * Tune in less than 15 seconds, usually less than 5 seconds.
MFJ #ad - Rf isolator is a 1:1 current Balun designed to be placed in line with a 50-Ohm coax. The rf isolator is effective from 1. 8 to 30 MHz.
The mfj-976 unit measures 12W x 6H x 5¾D inches. Mfjs fully balanced extremely wide-range T-network gives you simple, fast three knob tuning.
You get excellent 10 meter performance because of MFJs low minimum capacitance and exclusive Self-Resonance Killer high-Q AirCore roller inductor with silver plated contacts. The mfj-976 also tunes random wires and coax-fed antennas. No complicated switching between high and low impedance and switching in additional capacitance of L-networks.
MFJ #ad - It consists of 52 feet flat-top fed with 17 feet of 450 Ohm matching section ending in an SO-239 coax connector. Multi-band center-fed dipole antenna capable of 1500 watts.
1. MFJ
#adMFJ Enterprises Original MFJ-945E 1.6~60 MHz Mobile Antenna Tuner w/Watt Meter & Antenna Bypass Switch. 300 Watts
#adMFJ #ad - Tuner bypass Switch: Yes. Frequency range: 1. 8-60 mhz. Tuner maximum Power Rating: 300 watts. Connector: so-239 on Back Panel. Antenna tuner Type: Manual/ Mobile.More information #ad
| Brand | MFJ #ad |
| Manufacturer | MFJ #ad |
| Height | 2 Inches |
| Length | 8 Inches |
| Weight | 11.02 Pounds |
| Width | 6 Inches |
| Part Number | MFJ-945E |
| Model | MFJ-945E |
More information #ad
2. MFJ
#adMFJ-941E MFJ941E MFJ Enterprises Original HF Antenna Tuner with Mini Cross Meter, 300 Watts
#adMFJ #ad - Has 4:1 balun, 1000 Volt capacitors. An efficient 12 position airwound inductor gives lower losses and more power out. The beautiful aluminum cabinet has a durable scratch-proof multicolor Lexan front panel matches your rig perfectly and fits right into your station.Mfjs lighted cross-needle meter shows swr, 8 position antenna switch lets you select 2 coax lines, forward and reflected power all at a glance in 300/60 and 30/6 watt ranges, random wire/balanced line or dummy load direct or through.
More information #ad
The mfj-941e gives you a 300 watt antenna tuner that covers everything from 1. 8 - 30 mhz -- plus you get a lighted cross-needle meter with on/off switch, antenna switch and a 4:1 balun! The light uses 12 VDC or 110 VAC with MFJ-1312D * Not included.| Brand | MFJ #ad |
| Manufacturer | MFJ Enterprises, Inc. #ad |
| Part Number | MFJ-941E |
| Model | MFJ-941E |
More information #ad
3. MFJ
#adReplaces MFJ-259C, VHF/220 MHz 100-160 KHz, 280-520 KHz, MFJ-259D MFJ259D Original MFJ Enterprises Antenna Analyzer, .53-230 MHz
#adSuper easy to use! just set the bandswitch and tune the dial -- just like your transceiver. Complete ham radio test station with frequency counter, SWR/Resistance/Reactance/Coax Analyzer, RF signal generator, Capacitance/Inductance Meter and much more! 1 Year Manufacturer Warranty Included.
More information #ad
Large easy-to-read two line lcd screen and side-by-side analog meters clearly display your information. Ame great performance as the popular mfj-259C, but with two additional frequency ranges 100-160KHz and 280-520KHz. Swr and complex impedance are displayed instantly! Use 10 aa or ni-mh batteries not included or 110 VAC with optional MFJ-1312D not included.| Brand | MFJ #ad |
| Manufacturer | MFJ #ad |
| Height | 2 Inches |
| Length | 7 Inches |
| Weight | 2.27 Pounds |
| Width | 4 Inches |
| Part Number | MFJ-259D |
| Model | MFJ-259D |
More information #ad
4. MFJ Enterprises
#adMFJ Enterprises Original MFJ-949E 1.8-30 MHz 300 Watt Deluxe Versa Tuner II Antenna Tuner
#adMFJ Enterprises #ad - Mfjs inductor switch in the mfj-949e was custom designed to withstand the extremely high RF voltages and currents that are developed in your tuner. Tunes any antenna tunes out swr on dipoles, verticals, shortwave receiving antennas. More hams use mfj-949s than any other antenna tuner in the world! has mfjs full size 3 inch lighted cross needle meter not a puny "meter" you cant read.8 position super antenna switch lets you select two coax fed antennas, random wire/balanced line or built-in dummy load through your MFJ-949E or direct to your transceiver.
More information #ad
Has heavy duty 4:1 balun. Nearly anything! use coax, inverted vees, beams, random wires, mobile whips, random wire or balanced lines. Full 1. 8-30mhz operation custom designed inductor switch, 1000 volt tuning capacitors, Teflon insulation washers and proper L/C ratio gives you arc-free no worries operation with up to 300 Watts 1. 8 to 30 MHz. Lets you easily read swr, true peak forward and average reflected power simultaneously on 300 Watt or 30 Watt ranges. Custom inductor switch the inductor switch is the most likely component to burn up in any antenna tuner. Lamp has on/off switch, requires 12 vDC or 110 VAC with MFJ-1312D Not included.
| Brand | MFJ Enterprises #ad |
| Manufacturer | MFJ Enterprises #ad |
| Height | 3.5 Inches |
| Length | 10.62 Inches |
| Weight | 4 Pounds |
| Width | 7 Inches |
| Part Number | MFJ-949E |
| Model | MFJ-949E |
More information #ad
5. MFJ
#adMFJ Enterprises Original MFJ-994B 1.8~30 MHz Automatic Antenna Tuner 600 Watts SSB/CW IntelliTuner w/SWR/Watt Meter.
#adMFJ #ad - Over 10, 000 non-volatile memories for tuner settings * Highly efficient switching L-network matching circuit * 1. 8 to 30 mhz continuous frequency coverage.Built-in frequency counter * SO-239 coax fed antenna connector * Connector for random wire or single wire antennas. Automatically match antennas with impedance of 12 to 800 ohms * Handle 600 watts PEP SSB/600 watts CW * Tune in less than 15 seconds, usually less than 5 seconds.
More information #ad
Adjustable target swr 1. 5 to 2. 0 * adjustable swr threshold 05, low, 1. 0, or 1. 5 * lighted cross-needle SWR/wattmeter with high, and auto range options. Optional remote control * optional radio interface for compatible radios * Requires 12 Vdc at less than 1 amp for operation.| Brand | MFJ #ad |
| Manufacturer | MFJ #ad |
| Height | 2.8 Inches |
| Length | 9 Inches |
| Weight | 4.5 Pounds |
| Width | 10 Inches |
| Part Number | MFJ-994B |
| Model | MFJ-993B |
More information #ad
6. MFJ
#ad1500 Watts, MFJ-989D MFJ Enterprises Original 1.8-30 MHz Antenna Tuner Including Mars/WARC Bands
#adMFJ #ad - Rugged cabinet maintains hi-Q Made in the U. S. A. 500 pfair variable capacitors. New trueactivetm peak-reading Cross-Needle SWR/Wattmeter with new Super-bright LED. New high-voltage Current Balun. New aircoretm roller Inductor with new fast-tune Crank Knob.More information #ad
| Brand | MFJ #ad |
| Manufacturer | MFJ Enterprises, Inc. #ad |
| Height | 11 Inches |
| Length | 17 Inches |
| Width | 17 Inches |
| Part Number | MFJ-989D |
| Model | MFJ-989D |
More information #ad
7. MFJ
#ad1500W PEP, MFJ Enterprises Original MFJ-915 RF Isolator 1.8-30 MHz, SO-239
#adMore information #ad
| Brand | MFJ #ad |
| Manufacturer | MFJ #ad |
| Weight | 1.2 Pounds |
| Part Number | MFJ-915 |
| Model | MFJ-915 |
More information #ad
8. MFJ
#adMFJ Enterprises Original MFJ-976 1.8~30 MHz Balanced Antenna Tuner, 1500 Watts
#adMFJ #ad - The mfj-976 1500 watt fully balanced antenna tuner has a heavy duty 1:1 current balun that gives you superb balance and stays cool even at 1. 5 kW. True active peak reading lighted cross-needle swr/wattmeter lets you read swr, true peak or average forward and reflected power all at a glance on 300/3000 Watt ranges.The mfj-976 unit measures 12W x 6H x 5¾D inches. Mfjs fully balanced extremely wide-range T-network gives you simple, fast three knob tuning.
More information #ad
You can tune any balanced lines including 600 ohm open wire line, 450/300 Ohm ladder lines, 300/72 Ohm twin lead -- shielded or unshielded. Four separate 500 pf in two gangs gives you a total of 2000 pf for highly efficient low loss separation on 160 Meters. You get excellent 10 meter performance because of MFJs low minimum capacitance and exclusive Self-Resonance Killer high-Q AirCore roller inductor with silver plated contacts. The mfj-976 also tunes random wires and coax-fed antennas. No complicated switching between high and low impedance and switching in additional capacitance of L-networks.
| Brand | MFJ #ad |
| Manufacturer | MFJ Enterprises, Inc #ad |
| Height | 6 Inches |
| Length | 15 Inches |
| Weight | 13.8 Pounds |
| Width | 12 Inches |
| Part Number | MFJ-976 |
| Model | MFJ-989D |
More information #ad
9. MFJ
#ad52 Ft Long, MFJ Enterprises Original MFJ-1778M G5RV Junior Wire Antenna 40-10 Meters
#adMore information #ad
| Brand | MFJ #ad |
| Manufacturer | MFJ #ad |
| Height | 2.44 Inches |
| Length | 11.26 Inches |
| Width | 9.69 Inches |
| Part Number | MFJ-1778M |
| Model | MFJ-1778M |
More information #ad
10. MFJ
#adMFJ Enterprises Original MFJ-913 Balun 4:1 Current 300 Watts
#adMFJ #ad - So-239, stainless steel hardware with direct 14 gauge stranded copper wire connection to antenna. Heavy duty weather housing. 300 watt true current baluns/antenna center insulators that transforms 200 ohms to 50 ohms.More information #ad
Large low permeability ferrite cores easily handle full power. Measures 4¼ x 2 inch diameter. Transmission line transformer construction using 100 ohm characteristic impedance transmission line gives flat 160-10 Meter response.| Brand | MFJ #ad |
| Manufacturer | MFJ #ad |
| Height | 4 Inches |
| Length | 5 Inches |
| Weight | 0.44 Pounds |
| Width | 2 Inches |
| Part Number | MFJ-913 |
| Model | MFJ-913 |
More information #ad
